STANDARD LAP BELT INCLUDING FITTING KIT PACK OF 4
Suitable for front centre and load area side facing seats
Exmoor's own Basic floor mounting lap belt can be used for all side facing and early centre seats.
Supplied with a fitting kit so you have all you need to install including under floor load bearing plates and packing washers which are perfect if installing through rubber matting or carpet to ensure good fitting by clearing a hole to allow the spacer to have direct contact with the vehicle body.
These belts have been independently tested to exceed M3 Pull test requirements with a "A Regulation" 14 lap belt traction device was placed on the seat and the Exmoor Trim lap belts were used to secure the device to the seat. The traction device was then attached to our actuator. The minimum load that the belt needed to see to pass the testing was 9.34Kn, however the load that the belt saw was 14kn without failure this can be seen from the attached graph.
To purchase individual belts click HERE